Neilsen CT2214 Original Manual page 9

STEP 5: Attach the Control Handle
1. Remove the M6 lock nut on the upper left of the hopper (Pic.11)
2. Insert the original bolts through the support rod, wheel assembly bracket and control handle
and loosely secure together using a M6 lock nut.
3. Insert the M6x16 hex bolt through the hole on the hitch plate and hole on the support rod and
loosely secure using a M6 lock nut.
4. Use a M8x20 hex bolt to attach the control handle and wheel assembly bracket together and
loosely tight with a M8 lock nut (Pics.11&12).
STEP 6: Attach & Adjust the Tow Bar and Support Rod
1. Insert two M6x16 hex bolts through the holes on the support rod and the tow bar and loosely
tighten using two M6 lock nuts (Pic.13&14).
2. Put in position the tow bar and support rod and tighten all hardware in steps 5 and 6.
- 9 -