Neilsen CT2214 Original Manual page 8

STEP 3: Assemble the Tow Bar and Adjustable Handle Together
1. Remove the M8x25 hex bolt and M8 lock nut on the tow bar assembly (Pic.5)
2. Insert the M8x25 hex bolt through the hole at the bottom of the adjustable handle assembly
and the tow bar assembly.
3. Secure together using a M8 lock nut (Pic.6).
4. Put the adjustable handle assembly in a suitable position and tighten all hardware in the prior
steps 2 and 3.
STEP 4: Attach Hitch Studs and Support
1. Remove the hitch studs at one of end of the hitch rod (Pic.7).
2. Insert the hitch rod through the hole at the bottom of the adjustable handle and screw on the
hitch studs (Pic.8).
3. Insert tow hitch studs at each end of the hitch rod and through hitch support hole (left and right)
at the bottom of the hopper. Secure using M6 lock nut (Pics.9&10).
NOTE: Hitch studs should not be screwed too tight, they need to be able to rotate freely.
- 8 -