Table of Contents
Advertisement
When assembling or using the aerator spreader exercise caution at all times, the spikes are sharp
and may result in serious injury to the user or bystanders.
STEP 1: Attach Tow Bar Assembly to the Hopper
1. Remove the two M6 lock nuts in the bottom front of the hopper (Pic.1).
2. Put a M14 hex nut and Ø14 big washer to the support strut of the fluted disc assembly, then
attach the support strut to the card slot of the tow bar, and tighten with a Ø14 big washer and
M14 hex nut. (Pic.1).
3. Insert the original bolts through the holes on the beveled side of the tow bar assembly.
Secure using the M6 lock nuts (Pic.2).
STEP 2: Attach Handle Assembly to the Hopper
1. Remove one M6 lock nut from the front top of the hopper (Pic.3).
2. Insert the original bolt through the holes on the adjustable handle assembly. Loosely secure
using a M6 lock nut.
3. Insert one M6x16 hex bolt with an Ø6 big washer through the other hole at the top of the
hopper and the adjustable handle assembly.
4. Loosely tighten the parts together using the M6 lock nut (Pic.4).
Assembly Instructions
CAUTION
- 7 -
Advertisement
Table of Contents
