Pickle-ball SwiftNet Installation Instructions Manual page 7

Step Four: Separate the Netting from the assembly
Separate the Netting and End Posts from the Support Base by pressing in the interlock lever to release the Post
from the Vertical Support of the Base. Lay the Netting and Boom on the ground with the Boom still inserted
in either Top End Cap of the End Posts.
Step Five: Disassemble Boom
Now that all the tension has been released from the Boom and the Boom is on the court, pull the Boom out
from the Top End Cap on each end of the Netting. Separate each section of the Boom from the other and
place it in a bundle in the bottom of the carry bag.
Step Six: Gather the Netting
Fold the net in half lengthwise per the picture below. Pick up the end with the two Posts and begin rolling the
netting around the Posts by holding the Posts up in the air and letting the Netting dangle below. Gravity will
pull the Netting down which will help keep the Netting from twisting as you roll it up. Once the Netting is
gathered together, you can place it in the carry bag.
Page 7 of 9