Pickle-ball SwiftNet Installation Instructions Manual page 4

Tighten the Netting by pulling the Tensioning Net Cord straight down through the cam mechanism in the Top End
Cap on both sides of the Netting (be sure to pull the cord down through the teeth of the mechanism before
tightening). You will see the Boom gets forced downward as you pull the Net Cord downward. Do so until the
center of the Boom comes a few inches above the surface of the court.
Take the one Center Net Support (Shaped like the letter "A") and clip it to the center of the Boom pointing
down to the ground like the below picture. Making sure the Center Net Support is not caught in the Netting,
and the base of the Net Support is pointed downward, resume tensioning the Net Cord if needed, until the base
of the Net Support is firmly seated on the court.
Please note that over tensioning the top cord could cause one or both of the Base Legs to lift off the court
making the system unstable. The ideal tension is the point just past where the Boom brings the Center Net
Support into contact with the court.
Pull red cord straight down through the
cam mechanism so the teeth grab the
cord
Note the space between the court
and the bottom of the Center Strap
Support. As you continue to
tension the Boom, this space will
close until the Support is firmly
seated on the court.
Page 4 of 9