Advertisement
Usage
Seat
Remove by lifting one corner at a time or lift off one side only and pivot the seat up from the opposite side.
Install the seat by aligning opposite corners and snapping into place on the frame. Make sure that the seat is
square, and all 4 corners are snapped into place before sitting on chair.
Back
Loosen then remove the self-locking nut and screw that are securing the back assembly to the frame. Pull up on
the back assembly. Re-insert the screw through the holes in the chair frame. Hand start the nut onto the end of
the screw.
Adjustable Depth Back
Loosen knobs, slide back pad to desired position, tighten knobs.
Adjustable Sling Back
Loosen strap to decrease tension, tighten strap to increase tension.
Leg Rests
Adjust the height of the foot plate by depressing snap button and sliding foot plate mount up or down to obtain
correct height. Remove leg rest assembly by lifting up on the gooseneck to remove it from the receiver of the
front support.
Elevating Leg Rest
Adjust the height of the leg rest by depressing snap button and sliding foot plate mount up or down to obtain
correct height. Adjust the angle of the leg rest upward by lifting, lower by depressing the tab.
Arm Rests
Height-Adjustable Arm Rests
To raise the arm, push up on the armlock cap and pivot back the entire armrest. To lower the arm, pull down on
the front of the armrest until the arm latch locks onto the securing stud under the arm pivot.
Flip-Up Arm Rests
To raise the arm up, pivot the arm lock lever away from the armrest and armrest lock. Lift up on the armrest.
Remove by depressing the snap button and sliding it out of the armrest pivot.
Casters
Locking casters: To lock casters (option), push down on the front of the caster brake lever. To release caster
brake, push down on the rear of the caster brake.
Removing Casters: Loosen then remove the self-locking nut and machine screw that are in the chair frame
where the casters will be inserted. Insert caster so that it is flush with the frame. Re-insert the screw through
the holes in the chair frame and caster stem. Note: Screw head should be to the outside of the frame and the nut
to the inside. Hand start the nut onto the end of the screw Use a wrench and hex key to tighten the casters into
place. Repeat for second caster.
Wheels
Quick Release Axle
Depress button on the axle end to recess the ball locking pins and start the bolt thru the wheel. Place washer on
bolt end to inside of wheel. Continue depressing the button to insert the bolt into the wheel mount.
Note: The ball locking pins will secure the axle in place when the button is released.
Wheel Locks
To engage the wheel lock, push forward on the lever, to unlock pull back on the lever.
Note: If the wheel moves while wheel lock is engaged, the assembly needs to be moved slightly closer to
the wheel.
14
Advertisement
