Advertisement
STEP TWO: Burner Pan Positioning.
REAR WALL
TOP VIEW
STEP THREE: Gas Supply Connection.
TYPICAL INSTALLATION
f i r e - p a r t s . c o m
.
STEP FOUR: White Sand, Black Volcanic Ash and Ember
Magic Placement.
1.
Completely fill
BURNER
underneath
the
BAFFLE
appropriate PAN MEDIUM.
is for use with Natural G a s , the BLACK
VOLCANIC ASH is for use with Propane/LP
G a s . Use the ENTIRE CONTENTS of the bag
provided with the burner.
Be sure to completely cover BURNER TUBE. See
Figure 13.
2. Sprinkle a light covering of "EMBER MAGIC"
over the PAN MEDIUM. Pull apart "EMBER
MAGIC" fiber material to enhance the glowing
ember effect.
Figure 10
C
B
A
D
Figure 12
WARNING: DO NOT FLAME TEST FOR LEAKS.
PAN ,
including
PLATE,
with
the
The WHI TE S AND
1. Place
BURNER
PAN inside firebox as
far to the
rear as
possible. Then center
BURNER PAN left to
right.
See Figures 10 and
11.
ENSURE THAT GAS SUPPLY
TO FIREPLACE IS TURNED OFF
1. Apply pipe compound to threaded end of G A S S U P P L Y
FIREPLACE GAS
P I P E ( A ) . Thread 1 / 2 " F I P x 3 / 8 " F L A R E E L B O W ( B )
SUPPLY VALVE
onto GAS SUPPLY P I P E (A) and wrench tighten. See
Figure 12.
2. With BURNER PAN inside firebox at previously marked
position, thread (without pipe compound) one end of the
ALUMINUM CONNECTOR TUBE (C) to the 1 / 2 " F I P x
3/8" FLARE ELBOW (B) and wrench tighten.
3. Carefully bending ALUMINUM CONNECTOR TUBE (C),
align and connect, without pipe compound, to the FLARED
BURNER INPUT FITTING (D). Wrench tighten. Figure 12
NOTE: If bent into too small a radius the
ALUMINUM CONNECTOR TUBE (C) may kink or
break, causing air flow noise and/or leaks.
4. Turn gas supply to fireplace on.
5. Test all connections for leaks with soapy water solution. If
solution bubbles, turn off gas supply, re-tighten fitting and
recheck.
EMBER MAGIC
BURNER PAN MEDIUM
5
SIDE VIEW
Figure 11
BAFFLE
BURNER TUBE
ure 13
Fig
Advertisement
