Advertisement
ATTENTION
REQUIRED TOOLS AND MATERIALS:
Sealing Compound, Matches.
PREPARATION:
1. This Gas Log set must be INSTALLED IN A FULLY VENTED
METAL OR MASONRY FIREPLACE WITH A WORKING FLUE
THAT IS SAFE FOR BURNING A WOOD FIRE. The Flue MUST
BE FREE OF ANY OBSTRUCTIONS.
2. Turn off gas supply to fireplace.
3. Clean fireplace floor of any ashes.
4. Attach damper clamp over edge of fireplace damper blade as shown at
Figure 1. When installed properly, damper clamp prevents accidental full
closure of damper. If unable to install provided damper clamp, consult
IMPORTANT INFORMATION on front page of these directions.
STEP ONE: Burner Pan Assembly.
Attaching Burner Pan Legs (All Applications)
D
INSIDE
PAN
f i r e - p a r t s . c o m
C
B
A
Standard Match Lighted
• (For use only with Natural Gas Models CS, CS-W)
WARNING: A SAFETY PILOT MUST BE
INSTALLED ON ALL UNITS DESIGNED
OR CONVERTED TO BURN
PROPANE/LP GAS
1.
Apply pipe compound to threaded end of 3/8"
FLARED BRASS ELBOW (A). Do not apply pipe
compound to flared end. Thread into BURNER PAN
INLET (B) and wrench tighten. See Figure 3
Accessory Match Lighted Manual V17B Valve
• (For use only with Natural Gas Models CS, CS-W)
WARNING: A SAFETY PILOT MUST BE
INSTALLED ON ALL UNITS DESIGNED
OR CONVERTED TO BURN
PROPANE/LP GAS
ON
BURNER INLET
A
Figure 5
.
Figure 2
1. Apply pipe compound to the 3/8" inlet threads of V - 1 7 V A L V E ( A ) body. Thread
brass CONNECTOR FITTING (B) onto inlet threads of V - 1 7 V A L V E ( A ) body and
OFF
wrench tighten. Insert VALVE HANDLE (C) over V-17 VALVE STEM. See Figure 4 .
2. Apply pipe compound to the 3/8" outlet threads of V-17 VALVE (A) body. Thread into
BURNER INLET and wrench tighten. See Figure 5.
READ THESE INSTRUCTIONS
CAREFULLY BEFORE ASSEMBLY
Screw Driver, Adjustable Wrench, Pipe Wrench, Pipe
Damper Stop
Clamp
Figure 1
1.
Place FIBER WASHER (B) onto BOLT (A). Insert BOLT (A)
with FIBER WASHER (B) through the pre-drilled hole in LEG (C).
2.
Attach L E G ( C ) through pre-drilled hole at outside-bottom corner
of BURNER PAN with NUT (D). Wrench tighten NUT (D) securely
to ensure mechanical strength and a tight gas seal. Repeat for all four
legs. See Figure 2.
NOTE:
In extremely low fireplaces or where andirons are being
used, the LEGS may be left off. H O W E V E R , T O P R E V E N T
GAS LEAKING BENEATH THE BURNER PAN, THE NUT-
B O LT A N D F I B E R WASHER MUST BE INSTALLED TO
ENSURE GAS TIGHT INTEGRITY.
B
A
3
Damper
Figure 3
A
B
Figure 4
C
Chimney
Flue
Advertisement
