Table of Contents
Advertisement
HANDLING FUEL
1. The engine of the product is designed to run on a mixed fuel, which contains
highly flammable gasoline. Never store cans of fuel or refill the tank of the unit in any
place where there is a boiler, stove, wood fire, electrical sparks, welding sparks, or
any other source of heat or fire which might ignite the fuel.
2. Never smoke while operating the unit or refilling its fuel tank.
3. When refilling the tank, always turn off the engine and allow it to cool down. Take
a careful look around to make sure that there are no sparks or open flames any-
where nearby before refueling.
(1) Refill after cooling the engine.
4. Wipe spilled fuel completely using a dry rag if any fuel spillage occurs during refu -
eling.
5. After refueling, screw the fuel cap back tightly onto the fuel tank and then carry the unit to a spot 3
m or more away from where it was refueled before turning on the engine.
6. Do not inhale fuel fumes as they are toxic.
TRANSPORTATION
1. When hand-carrying the product, covers over the cutting part if necessary, lift up the product and
carry it paying attention to the blade.
2. Never transport the product over rough roads over long distances by vehicle without removing all
fuel from the fuel tank. If doing so, fuel might leak from the tank during transport.
© by WilTec Wildanger Technik GmbH
Seite 30
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Advertisement
Table of Contents
