Table of Contents
Advertisement
BLADES
Oil blades each gas tank filling. (MA6)
WARNING
Make sure that the blade bolts are well tightened. The blade assembly is de-
signed to automatically compensate for any play between the blades.
Sharpening (MA7):
Always keep the file or sharpener at an angle of 45° to the blade, and: Always
grind in the direction of the cutting edge.
Note: files cut only in one direction. Lift the file from the blade when returning to
start a new pass. Remove every burr from the edge of the blade with a slip stone.
Remove as little material as possible. Before refitting the sharpened blades, remove filings and then
apply grease. Do not try to sharpen a damaged blade: change it or take it to a Service dealer.
REDUCTION GEARBOX
Refill gear housing every 25 working hours. Use grease pump. Feed grease until
it comes out of the base of blades. (MA8)
PROCEDURES TO BE PERFORMED AFTER EVERY 100 HOURS OF USE
1. Remove the muffler, insert a screwdriver into the vent, and wipe away any car-
bon buildup. Wipe away any carbon buildup on the muffler exhaust vent and cylin-
der exhaust port at the same time.
2. Tighten all screws, bolts, and fittings.
3. Check to see if any oil or grease has worked its way in between the clutch lin -
ing and drum, and if so wipe it clean.
9. Storage
1. Oil the blade to prevent rust.
2. Empty the fuel tank and put the cap back on.
3. Remove the spark plug and pour a small amount of oil into the cylinder.
4. Rotate the crankshaft several times using the starting rope in order to distribute the oil. Put the
spark plug back in.
5. Wrap the engine with a plastic sheet.
6. Store the trimmer in a dry place, preferably not in direct contact with the floor and away from heat
sources.
© by WilTec Wildanger Technik GmbH
Seite 38
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Advertisement
Table of Contents
