First Time Operation; Connection To The Power Source; Connecting The Mbspider With The Configuration Pc - MB Connect Line mbSPIDER Series Quick Start Up Manual

First time operation

Depending on the device type, connect an antenna and insert a SIM card.

Connection to the power source

Before connecting the mbSPIDER to a network or PC, first ensure that it is
properly connected to a power source, otherwise it may cause damage to other
equipment. You should therefore follow the instructions given below!
Connect the (10-30 V DC) power source to the terminals 1 (V+) and 2 (GND).
Ensure correct polarity!
After switching on the
power source:
After 20-30 seconds:
After approx. 60 seconds:
The mbSPIDER is now
ready for operation.

Connecting the mbSPIDER with the configuration PC

To be able to access the web interface of the device, you must connect it to a
configuration PC using the supplied network cable.
10
ATTENTION
Power LED lights up
Ready LED flashes
Ready LED and Power LED lit up continuously.
.
.