Table of Contents
Advertisement
1.
Attach wheels. Install a wheel (37) on the drive side of
the axle (19). Install #10 Washer (52) onto clevis pin
(20) and insert assembly through the holes in the wheel
hub and axle. You may need to use Awl to align holes.
Secure with #10 Washer (52) and Hairpin Cotter Pin
(21). On the idle side of the axle, slide the other wheel
all the way onto the axle until the outer hole in axle
shows. If necessary, install the wheel washer (42) to
remove unwanted wheel movement. Secure wheel to
axle using the rue ring locking clip (26).
2.
Attach ground prop
(28) to frame with one
bolt (53) and nut (36).
3.
Attach handle braces
(27) to ground prop
(28) and Frame (25).
Use bolts (35) and
nuts (36) to attach
handle braces to the
round tube of ground
prop and frame.
Spreader
ssembly
52&20
52&21
53&36
2
42&26
35&36
35&36
Advertisement
Table of Contents
