Table of Contents
Advertisement
B
If it is impossible to find a satisfactory frequency, change the channel
setting on your transmitter, then press the "Auto Scan" button on the
headphones to find the corresponding channel.
To protect the transmitter and to save power, the transmitter will automatically
switch off after approximately four minutes if there is no audio signal, or the
signal that it receives from the audio source is too weak for proper reception. If
the signal returns to an acceptable level, then the transmitter will automatically
switch back on.
Charging the batteries
OFF
1. Switch
the receiver headphone.
2. To recharge the headphone batteries, place the headphones on the
transmitter, taking care to ensure that the charge contacts touch the
transmitter's charge pins and the green charging indicator is ON.
3. The charge process starts automatically and the green indicator light comes
ON. Be sure to charge new batteries for 24 hours before using them for the
first time in the headphones.
The green indicator light will be on continuously during battery charging.
Troubleshooting
Many times, problems have simple causes. We would like to give you some tips to
solve some common problems. Should these tips not help, please call us!
•
The headphones battery charge level may be too low. Recharge the batteries
or replace them with fully charged batteries.
•
The headphones output level is set too low. Adjust the volume to a suitable
level.
•
Ensure that the AC/DC adaptor is pushed fully into the power outlet and that
its cable is properly connected to the DC IN 12V connector on the transmitter.
•
Ensure that your TV set, Hi-Fi system or audio component is switched on and
set to a channel that broadcasts an audio signal or is in playback mode.
•
Use the headphones volume control to increase the sound level.
•
If distortion appears, press the "Auto Scan" button again. Use the channel
selector to change the transmitter's transmission frequency. Then you will
need to adjust the tuning control by press the "Auto Scan" button on the
headphones.
The headphones may be too far away from the transmitter. Move closer to it.
The audio signal input level is too low. Increase the volume from the audio
source of Hi-Fi, CD, or TV, etc.
Helpline No. UK/ North Ireland 0871 37 61 020 Rep. Ireland 1-800-992 508
Web Support www.medion.co.uk
Model Number: 82010
7
9
Advertisement
Table of Contents
