Care And Cleaning - Electrolux EHI635BD Installation & User Manual

22 electrolux.com.au

CARE AND CLEANING

Clean the appliance after each use.
Always use cookware with clean bottom.
IMPORTANT
Scratches or dark stains on the glass ceramic have no
effect on how the appliance operates.
To remove the dirt
1. Remove immediately: melted plastic, plastic foil,
and food with sugar. If not, the residue can cause
damage to the appliance. Use a cooktop scraper that
is specially designed for use on ceramic glass. Put the
scraper on the glass surface at an acute angle and
move the blade on the surface.
TROUBLESHOOTING
Problem
Red rings, limescale or water
rings, shiny metallic or other
discolouration, scratches/
shadows, bubbles or other
miscellaneous marks or stains on
ceramic glass cooktop surface.
Pitting of ceramic glass surface.
You cannot activate the
appliance or operate it.
An acoustic signal sounds and
the appliance deactivates. An
acoustic signal sounds when
the appliance is deactivated.
The appliance deactivates.
The residual heat indicator does
not come on.
The Automatic Heat Up function
does not operate.
The heat setting changes
between two levels.
Hob Hood function does
2
not work
Possible cause
Cooktop surface has not been cleaned
correctly. Cleaning/ maintenance of the
cooktop surface is not covered under
warranty. If a service call is placed to
clean the cooktop you will be charged for
the visit.
Spillovers of liquid with high sugar
content.
• You touched 2 or more sensor fields at
the same time.
• The Stop+Go function operates.
• There is water or fat stains on the
control panel.
You put something on one or more
sensor fields.
You put something on the sensor field.
The cooking zone is not hot because it
operated only for a short time.
The cooking zone is hot.
The highest heat setting is set.
The Power management is activated.
Object interrupting signal between hob
and the hood, or object covering the
control panel
2. Remove after the appliance is sufficiently cool:
limescale rings, water rings, fat, stains, shiny metallic
discolourations. Use a special cleaning agent for glass
ceramic or stainless steel.
3. Clean the appliance with a moist cloth and some
detergent.
4. At the end rub the appliance dry with a clean cloth.
Remedy
Use a ceramic glass cleaner such
as Cerapol.
These types of spills must be removed
immediately with a special scraper for the
glass. If not permanent damage to the
cooktop glass can occur which is not
covered under warranty.
Activate the appliance again and set the
heat setting in less than 10 seconds.
Touch only one sensor field.
Refer to the chapter "Operating
instructions"
Clean the control panel.
Remove the object from the sensor
fields.
Remove the object from the sensor field.
If the cooking zone operated sufficiently
long to be hot, speak to the service
centre.
Let the cooking zone become sufficiently
cool.
The highest heat setting has the same
power as the Automatic Heat Up function.
Refer to "Power management".
Move items obstructing signal or covering
control panel