Table of Contents
Advertisement
2.2
Inspect tool and dies before use. Replace any worn
or damaged parts. A damaged or improperly assem-
bled tool can break and strike nearby personnel.
Failure to observe this warning could result in severe
injury or death.
Electric shock hazard:
This tool is not insulated. When using
this unit on or near energized electri-
cal lines, use proper personal protec-
tive equipment.
Failure to observe this warning could
result in severe injury or death.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from ying
debris.
Pinch points:
• Remove battery before changing
dies, adapters, or jaws.
• Keep hands away from the crimping
tool head when crimping.
Failure to observe these warnings could
result in severe injury or death.
HE.17454 / TA04928 D Page 7 of 12
WARNING
WARNING
WARNING
WARNING
OPERATION
• Allow approximately 3 to 5 minutes of time to cool
down as tool automatically switches off when it gets
too hot.
• Do not secure this tool in a vise. This tool is
designed for hand-held operation.
• Use this tool for the manufacturer's intended
purpose only.
Failure to observe these precautions may result in
injury or property damage.
Charging the Battery
Read the instructions supplied with the battery charger.
LED Work Light (white)
This LED automatically turns on when the trigger is
pulled. It remains on for 10 seconds after the trigger is
released.
LED Indicator (red)
This tool is equipped with a special circuit board
incorporating several important features to inform the
user about the current status of the unit. The LED
signals in the following cases:
20 sec
20 sec/2 Hz
20 sec/5 Hz
20 sec/5 Hz
1 x
3 x
CAUTION
When
What it means
After
Battery is
inserting
inserted in tool
2 x
the battery
Low battery
After
Contact
working
TNB service
cycle
Tool has become
too hot
Error – manual
After
interruption of
crimp cycle prior
interruption
1 x
to completion
Error – automatic
After
opening of tool
working
due to exceeding
3 x
cycle
crimp force
Advertisement
Table of Contents
