Table of Contents
Advertisement
[ Audio Output ]
Select the analog audio setting based on the
audio device that is connected through the
analog audio jack.
•
[Stereo] – for stereo output.
•
[Multi Channel] – for multi channel
output.
Note
•
[Speaker Setup], [Speaker Volume] and
[Speaker Delay] settings are only available if
you have set the [Audio Output] setting to
[Multi Channel].
[Digital Output]
Selects the setting based on the digital
ampliÀ er/receiver that is connected through
the digital jack.
•
[Off] - Disables digital output.
•
[PCM] - Downmixs to PCM format (2
channel).
•
[All] - Supports multi-channel audio
formats.
[Volume]
Sets the default volume level when you play
a disc.
1. Press OK .
2. Press
to set the volume.
3. Press OK to conÀ rm and exit.
[Speaker Setup]
When you connect a speaker system, you can
optimize surround output for the connected
speakers.
•
[Front Speakers]
Option
Description
[Large]
Produce low frequency signal
below 120 Hz.
[Small]
Cannot produce low frequency
signal below 120 Hz.
22
EN
•
[Center Speaker] / [Rear Speakers]
Option
Description
[Large]
Produce low frequency signal
below 120 Hz.
[Small]
Cannot produce low
frequency signal below 120 Hz.
[Off]
No speaker is connected.
•
[Subwoofer]
Option
Description
[On]
A subwoofer is connected.
[Off]
No subwoofer is
connected.
[Speaker Volume]
Sets the volume level of each speaker to get
the ideal audio balance.
1. Press OK .
2. Select a speaker, then press
the volume.
3. Press OK to conÀ rm and exit.
[Speaker Delay]
Sets the delay time for the center and rear
speakers if they are placed closer to the
listening position, so that the sound output
from all speakers reach the listening position
at the same time.
1. Press OK .
2. Select a speaker, then press
delay time.
3. Press OK to conÀ rm and exit.
to adjust
and set the
Advertisement
Table of Contents
