Furuno NAVpilot-711C Manual page 2

Notes:
 The IF-NMEA2K2 software version must be 1.16 or higher.
 Set the IF-NMEA2K2 to high speed mode by cutting the orange wire. See
IF-NMEA2K2 installation guide for additional information.
 Software version of PCM, Pump Control Module, must be revision "T" or later.
 Navpilot 711C Processor unit (FAP7002) must be ver 1.27 or higher.
 Navpilot 711C Control head (FAP7011C) must be ver 1.08 or higher.
 If the Optimus CAN Bus is 24vdc, install the optional Gateway Adapter, part #
VIP-GTW-ADP
Specific settings in Navpilot 711C for EVCS systems
In the setup menu under, Ship's Characteristics, set the Boat Type to EVCS.
When you set the Boat Type to EVCS Boat, please note the following.
 NMEA0183 Port 2 will no longer show up in the setup menu. Port 2 is now used for
the EVCS connection.
 Dockside Setup Menu is not displayed when the Boat Type is set to EVCS Boat.
Rudder information is supplied by the EVCS so this part of the Navpilot setup is no
longer required.
Continue to installation instructions and connection diagrams
Overview
2