IBM 8203-E4A Manual page 23

Figure 14. Installation of a signal cable in a stand-alone system
6) Insert the DVD interposer card (C) by lining up the notches (F) with the side openings of the
card and carefully press the card back and down until the tab (E) clicks in place.
Figure 15. Installation of the DVD interposer card in the stand-alone system
5. Replace the control panel with power off. For instructions, see "Replacing the 8203-E4A, 8204-E8A,
8261-E4S, 9407-M15, 9408-M25, or 9409-M50 control panel with the power off" on page 5.
15
Chapter 1. 8203-E4A, 8204-E8A, 8261-E4S, 9407-M15, 9408-M25, or 9409-M50 control panel