Human Touch Perfect Chair Accessory Table Installing

Questions? Call Human Touch Customer Service at 800-355-2762.
© 2012 Human Touch , LLC.
®
PC-AccessoryTable-A0
ENG
Installing your Perfect Chair
accessory table.
Parts
Accessory table Bolt (2)
Note: The Perfect Chair accessory table fits all models except the PC-085 and PC-086. The 3/16-inch Allen wrench and two
bolts/washers required for installation are included (taped to the inside of the box end panel). No other tools are required.
Locate the two front bolts/washers underneath the right-hand armrest (Fig.1).
1
Using the 3/16-inch Allen wrench remove the two bolts and washers.
2
Discard the bolts and washers.
3
Align the two holes in the accessory table mounting arm with the two holes on front the right-hand armrest
4
(left by the bolts you just removed).
5
Install a washer onto each new bolt, then install and hand-tighten both bolts. IMPORTANT: Be sure you use
the new bolts, as they are longer than the bolts you removed from the armrest.
6
Using the 3/16-inch Allen wrench, tighten both bolts to secure the accessory table firmly to the armrest.
Bolts and Washers
(Fig.1)
®
Washer (2) Allen wrench
3/16" Allen Key
Accessory Table