Human Touch PC-600 Troubleshooting Manual
Perfect chair omni-motion silhouette
Hide thumbs
Also See for PC-600:
- Use & care manual (34 pages) ,
- Quick start manual (2 pages) ,
- Use & care manual (23 pages)
Related Manuals for Human Touch PC-600
Summary of Contents for Human Touch PC-600
-
Page 2: Getting Started
Getting Started 1) Reset the chair by unplugging it, then plugging it back in. 2) If the problem remains, unplug one of the connectors from the main control module underneath the chair and then plug it back in, making sure the plug is oriented in the same way as it was previously. - Page 3 4) Confirm whether the chair has a new-version recline controller, as follows:...
- Page 4 5) Select the issue that best describes the problem: Power Footrest Raise/Lower Pad Set Backrest Recline ZeroG Mode Noise...
- Page 5 What’s not working What are the symptoms? Here’s what to do: properly? There is no power to the 1) Check the entire length of the Power chair (no functions work) power cord for damage; if the power cord is damaged, replace the control module w/power cord.
- Page 6 What’s not working What are the symptoms? Here’s what to do: properly? module w/power cord. The backrest will not 1) Replace the backrest actuator. Backrest Recline recline or incline. 2) If the problem remains, replace the recline controller. 3) If the problem remains, the main control module.
- Page 7 What’s not working What are the symptoms? Here’s what to do: properly? control module. The pad set is 1) If there is a Jade Heat system Pad Set uncomfortable between installed, make sure there are no the shoulders. folds or buckles in the hook- and-loop fasteners that secure the Jade Heat pad to the inside of the body pad.
- Page 8 What’s not working What are the symptoms? Here’s what to do: properly? installation. 2) If the rear of the armrest is touching the backrest pad during recline/incline: a) Use a Phillips-head screwdriver to remove the three screws from underneath the armrest cap, then remove the armrest cap.
- Page 9 What’s not working What are the symptoms? Here’s what to do: properly? far toward the outside of the chair as possible. d) Tighten the two screws to secure the metal plate. e) Place the armrest cap into position, then replace the three screws to secure it.