Human Touch Perfect Chair User Manual

Install a locking knob on the underside of each mounting
9
pin to secure the table firmly to the mounting brackets.
Install the locking knob large end facing up.
10
Your PC Spanner table installation is now complete.
Retain the four bolts you removed from your chairs in
case you want to return your chairs to their original
configuration. You can also add more spanner tables
and chairs to expand your layout. Enjoy!
Questions? Call Human Touch Customer Service at 800-355-2762.
Please send any questions or comments regarding these instructions to: documentation@humantouch.com
© 2011 Human Touch , LLC.
®
PC-WST-A0
Mounting
pin
Mounting
Locking knob
bracket
Installing your Perfect Chair
Parts
Mounting screw
pin (4)
Table Mounting bracket (2)
GET READY
Place the first chair on its side on a soft surface with the
1
side on which you want to mount the table facing up.
Remove the two bolts shown in Fig. 2. Save both
2
bolts in case you wish to restore your chair to its
original configuration later.
NOTE: While removing the two screws, one or
more barrel nuts may fall out of the cross bar
on the chair frame. If this occurs, reinsert the
barrel nut onto the cross bar, then turn it so
that the notch in the barrel nut runs parallel
to the chair leg.
Wedge Spanner Table.
®
Allen key
Locking knob (4)
Long bolt
(1 long, 1 short)
Small spacer (6) Short bolt
Spacer wire (1 long, 1 short)
Back leg
Front leg
Fig. 1
Back leg
Front leg
Fig. 2