Brother P-touch PT-D800W Product Safety Manual page 9

P-touch Labeling System
 Store the P-touch labeling system on a flat, stable surface, such as a desk or in a drawer.
 Always use only the AC adapter (AD9100ESA) designed for the P-touch labeling system, and
plug it into an outlet with the specified voltage. Failure to do so could result in damage or failure
of the P-touch labeling system.
 If you notice heat, an abnormal odor, deformation, or discoloration of the P-touch labeling
system, or anything else unusual while using or storing the P-touch labeling system,
immediately discontinue the use of the P-touch labeling system, disconnect the AC adapter
(AD9100ESA), and remove the battery.
 DO NOT leave the P-touch labeling system or any label tape within the reach of young children.
 DO NOT place any heavy objects on top of the P-touch labeling system.
 DO NOT use the P-touch labeling system in places with high humidity or moisture, such as
bathrooms.
 DO NOT allow the P-touch labeling system to get wet, for example, by handling it with wet hands
or spilling beverages onto it.
 DO NOT disassemble or modify the P-touch labeling system.
AC adapter (AD9100ESA)
 If you do not intend to use the P-touch labeling system for an extended period of time,
disconnect the power cord from the electrical outlet.
 When disconnecting the power cord from the electrical outlet, always hold the plug. Never
disconnect by pulling the wiring.
 DO NOT overload an electrical circuit with the power cord.
 DO NOT disassemble or modify the AC adapter.
 DO NOT allow the AC adapter / power cord / plug to get wet, for example, by handling them with
wet hands or spilling beverages onto them.
Cutter
 DO NOT open the tape compartment cover when operating the cutter unit.
 DO NOT apply excessive pressure to the cutter unit.
8
CAUTION