General Precautions - Brother P-touch PT-D800W Product Safety Manual

Rechargeable Li-ion Battery (Optional)
 At the time of purchase, the rechargeable battery is slightly charged so that the operation of the P
labeling system can be verified; however, before you use the P-touch labeling system for the first time,
you must fully charge the battery using the AC adapter.
-
 If the P touch labeling system will not be used for a long period of time, remove the rechargeable
-
battery from the P touch labeling system, and then store it in a location where it is not exposed to static
electricity, high humidity, or high temperatures (storage at temperatures between 59F and 77F (15C
and 25C) and humidity between 40% and 60% is recommended). To maintain the efficiency and life
of the rechargeable battery, charge it at least every six months.
 If you notice anything unusual about the rechargeable battery the first time it is used, for example
overheating or rust, STOP using the battery. Contact Brother customer service.
P-touch Labeling System
 DO NOT transport the P-touch labeling system while cables are connected to the AC connector and
USB port. The connector and ports could be damaged.
 DO NOT install the P-touch labeling system near any device that will cause electromagnetic
interference.
The P-touch labeling system may malfunction if left near a device, such as a television, radio, or
microwave oven.
-
 DO NOT use the P touch labeling system in any way or for any purpose not described in this guide.
Doing so may result in injury or damage to the P-touch labeling system.
 DO NOT put any foreign objects into the tape exit slot, AC adapter outlet, USB port, or any other part
of the P-touch labeling system.
DO NOT touch the print head (see page 5) with your fingers. Use the optional print head cleaning

-
cassette (TZe CL6) or a soft wipe (e.g. a cotton swab) when cleaning the print head (see the User's
Guide).
 DO NOT clean any part of the P
the optional print head cleaning cassette (TZe-CL6), or a soft, dry cloth.
-
 DO NOT place the P
in any location exposed to extremely high or low temperatures, high humidity, or dust. The standard
operating temperature range of the P
for labels.
 DO NOT leave any rubber or vinyl, or products made of rubber or vinyl, on the P
for an extended period of time, otherwise the P-touch labeling system may become marked.
 Depending on the environmental conditions and the applied settings, some characters or symbols may
be difficult to read.
 Use Brother TZe tapes, FLe labels, HGe tapes and HSe tubes with the P-touch labeling system.
 DO NOT pull or apply pressure to the tape in the cassette to avoid damaging the P-touch labeling
system.
 DO NOT try to print labels using an empty tape cassette or without a tape cassette in the P-touch
labeling system. Doing so will damage the print head.
 DO NOT attempt to cut the tape while printing or feeding since this will damage the tape.
 Depending on the location, material, and environmental conditions, the label may unpeel or become
irremovable, and the color of the label may change or be transferred to other objects.

General Precautions

-
touch labeling system with alcohol or other organic solvents. Use only
touch labeling system in direct sunlight, near heaters or other hot appliances, or
-
touch labeling system is between 50F and 95F (10C and 35C)
-
touch
-
touch labeling system
9