Table of Contents
Advertisement
4. Your vehicle is equipped with an aluminum
G
template
that has pre-drilled holes in it that will
need to be removed.
The template holes are used to locate the bolts for
the rear rack support and the ice auger rack kit.
INSTALLATION
1. Place provided bolts
into the approximate location as shown.
2. Reinstall template making sure tabs are into the
opening in the T-slot and newly place bolts are
aligned with the holes in the template.
NOTE
a
into T-slot and slide them
Instr 9927953
3. Place the front auger mount
bolts installed in the previous step. Loosely fasten
s
nuts
so that the support bracket is held in place
but do not tighten.
4. Install the auger mount plate
running board tube support and onto the front
auger mount
locking nuts
s
nuts
to specification provided.
Rev 01 2017-07
Page 3 of 8
q
onto the two new
y
around the
q
using supplied screws
s
as shown. Torque all six locking
TORQUE
8.5 Ft. Lbs. (12 Nm)
o
and
Advertisement
Table of Contents
