Atwood MPD 90222 Installation Manual

EngLiSH - FranÇaiS
This water heater design has been certified by the Canadian
Standards Association for installation in recreation vehicles. This
water heater is not for use in marine applications.
service calls & quesTions
Location and phone numbers of qualified Service Centers can
be found at our website http:/www.askforatwood.com or call
866.869.8116 to locate a Service Center.
safeTy alerT symbols
Safety Symbols alerting you to potential personal safety hazards.
Obey all safety messages following these symbols.
m
warning
avoid possible
injury or death
m
fIre Or exPlOsIOn
• If the information in this manual is not followed
exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
– Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
WHaT To Do if you smell Gas
• Evacuate ALL persons from vehicle.
• Shut off gas supply at gas container or source.
• DO nOT touch any electrical switch, or use any phone
or radio in vehicle.
• DO nOT start vehicle's engine or electric generator.
• Contact nearest gas supplier or qualified Service
Technician for repairs.
• If you cannot reach a gas supplier or qualified Service
Technician, contact the nearest fire department.
• DO nOT turn on gas supply until gas leak(s) has been
repaired.
– Installation and service must be performed by a
qualified installer, service agency or the gas supplier.
m
caution
avoid possible
injury and/or property damage
warning
literature number
•Installation •Operation •Maintenance
explanation of model number:
oD_____________________ on Demand
45________________ input in 1000's btu
01__________ Generation
m
criticaL inStaLLation warningS
• Install in recreation vehicles only. RV's are recreation vehicles
designed as temporary living quarters for recreation, camping,
or travel use having their own power or towed by another vehicle.
• All combustion air must be supplied from outside the RV, and all
products of combustion must be vented to outside the RV.
• DO NOT vent water heater with venting system serving another
appliance.
• DO NOT vent water heater to an outside enclosed porch area.
• Protect building materials from flue gas exhaust.
• Install water heater on an exterior wall, with access door opening to
outdoors.
• DO NOT modify water heater in any way.
• DO NOT alter water heater for a positive grounding system.
• DO NOT HI-POT water heater unless electronic ignition system
(circuit board) has been disconnected.
• DO NOT use battery charger to supply power to water heater even
when testing.
Do not install close to opening door or under room slide-out where
the vent or inlet louvers can be obstructed.
USA and Canada – Follow all applicable state and local codes. In the
absence of local codes or regulations, refer to the current standards
of:
— Local codes or, in the absence of local codes, the National Fuel Gas
Code, ANSI Z223.1/NFPA 54 and/or CSA B149.1, Natural Gas and
Propane Installation Code.
— Local codes or, in the absence of local codes, the Standard on
Recreational Vehicles, NFPA1192 and/or CAN/CSA-Z240 RV.
CUTOUT Requirements
OEM and Aftermarket – Unit can be installed in Atwood, Suburban and Girard
openings. Unit can also be installed through the wall from exterior, or prior to
erecting wall into place at OEM manufacturing facility.
Atwood 6 Gallon Opening
Suburban 6 Gallon Opening
Atwood 10 Gallon Opening*
Suburban 10 Gallon Opening*
1
MPD 90222
l.P. Gas
on DemanD
WaTer HeaTer
oD45, oD50, oD55
Effective 9.22.11
12.7 H x 16.25 W x 17.62 D
12.7 H x 12.7 W x 19.2 D
15.75 H x 16.2 W x 20.6 D
16.2 H x 16.2 W x 20.5 D
*Door/Adapter Kit Required
models