How To Install Product - Nuga N4 User Manual

How to Install Product

Installing the product frame
and main mat
Place the MAIN MAT on top of the MAIN
BASE FRAME, and bring it close to the two
supports below the MAIN BASE FRAME.
N4
Attach the synthetic leather at the middle
connected to the MAIN MAT to the
VELCRO on the SUB MAT.
Covering the MAIN MAT
with an outside cover
Align the outside cover on the VELCRO
part on the front of the main mat and attach
it to the bottom side of the main device.
Insert the bottom part of the MAIN MAT
into the outside cover insertion hole and fix
it place using the VELCRO.
Preparing product
Take out the controller, power cord,
external projector, projector cover, and
low frequency pad.
Connecting the devices
to the connector
① Controller
② Low frequency pad
③ External heating projector
Connect the above devices in this order.
Caution
Make sure the groove in the cable
connection part is pointing upward.
If you do not connect the cable
accurately into the groove, it will lead
to malfunctions and device failure.
Connect thePower Cable
to the Sub Mat
Connect the power cables to the
MAIN MAT and SUB MAT, as shown
in the figure.
Turning on the power
Connect the power cord to the power
input part on the side of the MAIN
MAT and turn on the power switch.
Caution
Make sure the power switch is turned
off when connecting the power cord.
Otherwise, it may cause malfunctions
and device failure.
Production Installation and Use