Resetting The Clock - Ceridian Dayforce Tuff Clock User Manual

13 RESETTING THE CLOCK:

Reset the clock by pressing the reset button next to the connectors
below at the rear of the clock.
Alternatively, use the Reset control on the Administrator Mode Screen,
or (if there is no battery backup installed), temporarily remove external
power from clock.
14 CLOCK INFORMATION AND SETUP STATIC IP:
1.
On the home screen, touch and hold the Welcome to Dayforce
HCM message.
After a few seconds, the application prompts you to type the
admin mode PIN:
2.
Type the administrator mode PIN.
Note: The default PIN is 4110, but may be changed without
notice by system administration.
3.
Tap the Enter button.
The clock displays the Administrator Mode screen. To view the current
clock IP and MAC address, tap Clock Information
To set up Static IP:
1. Tap Network Setup and choose Ethernet Configuration.
DF Tuff
Page 26 of 31