Table of Contents
Advertisement
Available languages
Available languages
8- Connect the power cord (not supplied) :
- Unscrew the 4 screws from the plate a few millimeters where the power supply
and electronic board are installed.
- Remove the power supply block from the box by shifting then pulling towards yourself:
the teardrop-style holes will make it possible to extract the power supply without
completely loosening the screws.
- Remove the transparent plastic protective sleeve.
- Attach power supply cable to power supply unit respecting polarity:
L, N, E (Live, Neutral, Earth)
Attach the three cables together the using the plastic collar provided.
9- Connect the rotating beacon's connection cable (2 wires) with the control box to the green
connector of the electronic board in OUT mode. Respect polarity: V- (earth), V+ (+24V).
25 mm unsheathed cable.
7 mm stripped wires.
Attach the two cables together the using the plastic collar provided.
10- Put the transparent plastic protective sleeve back in place and reposition
the power supply unit.
11- Close the control box.
All cables should be tightly wired inside the control box (no traction).
We advise against inserting excess cable length inside the control box.
Harmonys flash powered up (box open):
6
« Test » Button: press once to test the operation of the flashing beacon (start
and stop of the test mode).
- The « ~ » LED (green) indicates the presence of power.
- T he « Ψ » LED (green/red) indicates the network status.
> Green = Network synchronisation OK
> Red = Network synchronization error
After the product have been powered up, it waits for a command from the mas-
ter clock.
EN
Advertisement
Table of Contents
