Installation - Bodet HARMONYS Flash Installation And User Manual

2. INSTALLATION

1- Determine the location where the Harmonys Flash rotating beacon will be installed according to the location of the
control box: a 5-meter cable is provided to ensure the link between the 2 elements.
2- Determine the placement of the Harmonys Flash control box, ensuring that the power supply (mains socket) and
Ethernet cable are within reach.
3- Open the box by unscrewing the 4 screws
cover from the box.
4- Attach the control box in position using 3 screws
Note: The 4th screw can be used
3 nuts on the electronic board
5- Pass the network cable and the rotating beacon cable through the largest of the two
cable glands. The mains power supply cable should fit alone through the smallest
cable gland.
6- I nstall the rotating beacon in its final position. Ensure that it is correctly attached to the
cable clips and also to its support (e.g. the wall) to avoid vibrations.
7- Mount the information sign as close as possible to the beacon.
250
PG16
PG7
The equipment must not be powered on until the mounting is completed.
with a flat-tip screwdriver. Remove the
1
to attach the control box. Unscrew the
3
to access the final control box screw
4
184
184
97,5
195
2
. Refer to the dimensions below.
250
Dimensions for mounting
View of the inside of the control box
.
3
2
310
37
140
EN
1
3
4
5