Bodet HARMONYS Flash Installation And User Manual page 10

This page is used to enable device supervision, to define the information to be transmitted and the destination server.
One or more settings can be defined and configured as alarms.
The following information is displayed:
• SNMP - SNMP Trap: If enabled, error messages are sent to the SNMP Manager(s) automatically.
• Version: choice of SNMP protocol version
• Tick SNMP Trap box: activates (or not) the automatic sending of error messages to SNMP managers.
• SNMP Manager 1/2/3: IP addresses of servers receiving alerts from the clocks. SNMP Manager redundancy
• Community: A set of clocks defined by the user. All the clocks on the network must have the same
• Reboot: This setting is used to detect a clock reboot.
• Scheduled melody: This parameter triggers an alarm when a programmed melody is played.
• Manual melody: This parameter is used to trigger an alarm when melody is initiated manually.
• Alert melody: This parameter triggers an alarm when an alert melody is played.
• Web access: This setting is used to trigger an alert if a user connects to the web server of the clock.
• Authentication failure: This setting is used to trigger an alert if a user sends an incorrect ID to the web server
• Repeater failure: This parameter triggers an alarm when a fault occurs on the repeater.
• Periodic Status: This setting is used to verify that the device is still working correctly (in case alerts are
10
increases the reliability of alerts.
Community name.
of the clock.
"lost"). This verification is carried out at a set frequency
.
EN