Pegasus MD Series Instructions Manual page 40

Press the knee switch.
●
If there is nothing wrong, the display shown on the right will
be displayed.
If the input signal is abnormal, the following messages will
be displayed.
If the knee switch (fullness application changing switch) is
●
under abnormal conditions
If the cutter switch (finger switch) is under abnormal
●
conditions
Note
If the above test messages or error messages are not
displayed on the screen, check the input switch cable.
Select "ON" with AT in the function select mode.
Otherwise the test cannot be performed.
● Press the finger switch (cutter switch) or CUTTER key
(on the controller). The tape cutter will get activated.
Press again the finger switch or CUTTER key in order
●
to check to see if the tape cutter gets activated.
W ARNING
W ARNING
To prevent accidents, never bring your hands and/or
fingers close to the tape cutter.
S W I T C H T E S T
P U S H R U F F L E S W
S W I T C H T E S T
I N P U T S I G N A L
S H O R T ？
I N P U T S I G N A L
S H O R T ？
P U S H
(Operate the tape cutter)
CUTTER カッター CUTTER カッター
P U S H
(Operate the tape cutter)
Ｏ Ｋ ！
（ＰＢ２）
（ＰＢ３）
A T T E S T １
C U T T E R SW
A T T E S T ２
C U T T E R SW