Pegasus MD Series Instructions Manual page 27

F F u u n n c c t t i i o o n n s s e e l l e e c c t t i i n n g g m m o o d d e e
D D i i s s p p l l a a y y
F F u u n n c c t t i i o o n n
To select whether you use the AT function or not
■
If you use the AT function, select "ON".
○
The motor automatic stop function can be used with the AT function "ON" (a relay cord for the motor optional function is
＊
needed). Regardless of "ON" or "OFF" in the AT END function mode (see page 32), the machine motor stops autom
atically at the value preset (by stitch counting) with the AT END function.
If you do not use the AT function, select "OFF".
○
The following 4 selectable cutter operation modes are available according to the seaming process and products (see page
○
32).
1
Double cutting The cutter operates automatically
. ･･･
at the start and end of seaming.
3
. Rear cutting ･･･ The cutter operates automatically
only at the end of seaming.
S S w w i i t t c c h h e e s s
▲ ▼
or ････････････
････････････
････････････
AT (automatic tape cutter) function
INC. INC.
増 増
DEC. DEC.
減 減
To select ON OFF for the AT function
To go to the Mesh counter mode display
To return to the sewing mode display
or
2
Front cutting
. ･･･
4
. Manual ･･････ You can actuate the cutter manually
with the finger switch (option) or the
key (on the console box).
Be sure to operate the cutter with no
fabric under the tape.
The cutter operates automatically
only at the start of seaming.
CUTTER カッター CUTTER カッター