Factory Service - LGB 22852 Instructions Manual

Lubrication
The axle bearings and drive rod
ends should be lubricated occa-
sionally with a small amount of
LGB Maintenance Oil (50019).
Cleaning
This model can be cleaned using
a mild detergent and gentle
stream of water. Do not immerse
this model. If this model is equip-
ped with sound electronics, do
not expose the speaker directly to
water.
Replacing the light bulbs
Front and rear lanterns: Remo-
ve the ring around the lantern
lens. Carefully pry the lens away
from the lantern. Using tweezers,
remove and replace the bulb.
Reassemble.
Cab light: Using tweezers, remo-
ve and replace the bulb.
Replacing the smoke generator
Pull the safety ring out of the
smoke stack (Fig. 5). Use pliers or
tweezers to pull the old smoke
generator out of the stack (Fig. 6).
Cut the wires to the old generator
and attach them to the replace-
ment generator (Fig. 7). Insulate
the connections and push the
replacement generator into the
stack. Reassemble.
Replacing the traction tire
- Use a small, straight-blade
screwdriver to gently pry the old
traction tire out of the wheel
groove.
- Gently warm the new traction
tire in a dish of warm water.
- Use a small, straight-blade
screwdriver to gently pry the
new traction tire into the wheel
groove.
- Make sure that the traction tire is
completely in the wheel groove.
Replacing the motor
The gearbox must be removed to
replace the motor:
- Remove the hex head screws
joining the drive rods and
connecting rods at the rear
wheels.
- There are three screws on the
bottom of the gearbox. Remove
the front and rear screws. Do not
remove the center screw.
- Pull the gearbox away from the
chassis. The top plate of the
gearbox will remain attached to
the chassis.
Attention! Make sure that the
motor and other parts do not fall
out of the gearbox.
- Replace the motor. Reassemble.
Attention! If the motor is repla-
ced, generously lubricate the
gears with LGB Gear Lubricant
(51020).
Attention! Make sure that the
drive rods do not bind. Binding
can cause serious damage to the
model.
Replacing the brushes
and wheelsets
Remove the three screws on the
bottom of the gearbox. Remove
the bottom of the gearbox. Note
the position of the power strips. If
necessary, replace the brushes or
wheelsets. Reassemble.
Attention! If the wheelsets are
replaced, generously lubricate
the gears with LGB Gear Lubri-
cant (51020).
Attention! Make sure that the
drive rods do not bind. Binding
can cause serious damage to the
model.
Maintenance parts
50010 Smoke and Cleaning
Fluid
50019 Maintenance Oil
50020 Special Tool Set
51020 Gear Lubricant
55020 Multi-Train System
Decoder
55026 Decoder Interface Cable
62201 Standard Motor
63120 Brushes, 14mm, 16mm,
8 pack
65853 Smoke Generator, 5V
68511 Plug-In Bulb, Clear, 5V,
10 pack
69104 Traction Tire, 37.5mm,
10 pack

FACTORY SERVICE

For factory authorized service,
contact an authorized retailer or
send this product to one of the
LGB service stations listed below:
Ernst Paul Lehmann Patentwerk
Saganer Strasse 1-5
D-90475 Nürnberg
GERMANY
Telephone: (0911) 83707 0
11