Ingersoll-Rand 2200 Series Operation And Maintenance Information
Hide thumbs
Also See for 2200 Series:
- Operation & maintenance information (8 pages) ,
- Operation and maintenance information (8 pages) ,
- Installation and maintenance information (12 pages)
Related Manuals for Ingersoll-Rand 2200 Series
Summary of Contents for Ingersoll-Rand 2200 Series
- Page 1 Part No. 49999-498 Edition 2 February 2009 CCN: 45633591 2200 Series Drill Model 7695 (325 rpm) Operation and Maintenance Information Save These Instructions...
-
Page 2: Air Supply Requirements
After disassembly is complete, all parts, except sealed or shielded Bearings, should be washed with solvent. To relubricate parts, or for routine lubrication, use the following recommended lubricants: Where Used Ingersoll Rand Part # Description Air Motor 29665 1 qt. Spindle Oil O-Rings &... -
Page 3: Parts And Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled, degreased and parts be separated by material so that they can be recycled. Tool repair and maintenance should only be carried out by an authorized Service Center. Refer all communications to the nearest Ingersoll Rand Office or Distributor. 45633591_ed2... -
Page 4: Part Description
2200 Series Drill Model 7695 (325 rpm) Parts List Item Part Description Part Number Item Part Description Part Number Snap Ring (2 Required) Y111-3 Bearing 33705 O-Ring (2 Required) Y325-8 Motor Assembly 41522 Regulator Valve 36975 Spacer 33699 Regulator Body... -
Page 5: Housing Disassembly
Use correct tools and fixtures when servicing this tool. • Don’t damage O-Rings when servicing this tool. Use only genuine Ingersoll Rand replacement parts for this tool. When ordering, specify part number, description, tool model number and • serial number. -
Page 6: Motor Assembly
Auxiliary Gearing Motor Assembly • Assemble snap ring (43) to groove in spindle, aligning open • Pack bearings with 33153 grease. portion of snap ring with hole for shaft. • Assemble bearing (25) to end plate (26), pressing on outer race •... - Page 7 Notes:...
- Page 8 © 2009 Ingersoll Rand Company...