Table of Contents
Advertisement
Description
HEATED 55-GALLON FOLLOWER PLATE ASSEMBLY
560mm (22") o.d.
Order wiper rings separately
Standard Finned Bottom
Smooth Bottom
55-GALLON HEATED FOLLOWER WIPER RINGS KITS
560mm (22") o.d.
Kit contains upper and lower hoses and clamp
Silicone Rubber/Silicone Rubber
Silicone Rubber/Silicone Rubber, Fiber Drums
Silicone Rubber/Steam
AIR CONTROL MODULE FOR RAM AND HYDRAULIC CONTROL
4 Regulator module contains controls for ram up, ram down, blow-off and motor
0.7 MPa (7 bar) (100 psi) MAXIMUM WORKING PRESSURE
DRUM CLAMP, HEAVY DUTY
(Includes all hardware to attach to ram cylinders)
Attach to ram cylinders to center the drum in place and prevent drum from moving. The
heavy duty drum clamp is used in applications where excessive material adhesion may be a
problem.
LOW LEVEL DRUM KIT
Lights a red beacon signal when the drum is empty
PUMP MOUNTING KIT
Used to secure pump assembly to ram. Includes follower rods and brackets.
PUMP AIR MOTOR MOUNTING KIT
Used in heated applications to connect the heated Check-Mate
Senator air motors.
HOSE SUPPORT KIT
Supports hose to ram to prevent hose kinks
VENT HOOD KIT
Used for venting toxic fumes. Required for Polyurethane Reactive (PUR) supply units.
HYDRAULIC FLUID
20 liters (5 gallons)
MATERIAL PUMP INACTIVITY KIT
Used to shut down the heaters if there is no pump activity. Contains proximity switch,
electronic timer, and the hardware necessary to install it in the supply unit.
MATERIAL PUMP REBUILD KIT
See Form# 308–570
HEATER/SENSOR REPAIR KIT
Contains heaters, sensors and wires for replacing heaters and sensors
7-DAY TIMER KIT
Contains electronic timer and the hardware necessary to install the timer in the electrical
control panel
Accessories
Use Only Genuine Graco Parts and Accessories
800 pump to Bulldog and
Part No.
C32435
918–470
C31009
C31008
C31007
918–425
918–395
918–394
C32434
C03510
C34220
C32451
169–236
617–334
C32202
C78167
310–534
Advertisement
Table of Contents
