Page 1
Expert D unit and then switches the unit on. The green ready LED lights up. Programming mode of the Expert D is now active. If for the first time an Expert D is stuck on to computer, receive message at the computer „the new hardware was found “.
Page 2
If the equipment is correctly attached, the adjacent opinion appears. Click on the button „Install“. The program unpacks the required files into the temporary register „C:\TEMP\Expert D Firmware Updater Version X.X“ and starts automatically. If the unit is not connected to the...
Page 3
If the equipment were attached correctly, the above window appears. For programming click on the button „start”. While programming runs, do not switch off the computer or separate the equipment! The equipment was successfully programmed and can be separated and switched off from the computer.