Controls; Using Your Water Flosser - ETEKCITY EWF-32 User Manual

Controls

: Releases jet tip from
water flosser.
: Turns the water flosser on
or off.
: Cycles through Normal, Soft,
and Pulse modes. You can
change the mode at any
time, including when the
water flosser is off.
Figure 1.1
Figure 1.2
Using Your
Water Flosser
Note:
• Before first use, fully charge
the water flosser
(see Charging the Battery,
page 10 ).
• Use Soft mode for the first
2 weeks to allow your gums
to get used to the water
flosser. If bleeding continues
after 2 weeks, see a dental
professional.
1. Insert the jet tip securely
into the jet tip port. You will
hear it click into place.
2. Make sure the water flosser
is off and the port plug is
covering the charging port.
Open the water tank lid and
fill the water tank with tap
water. Press the lid closed
firmly.
3. Press to select the
water pressure mode.
4. Point the jet tip at the
gumline of your back teeth
and slightly close your
mouth to prevent water
from spraying out. Lean
over a sink and press and
hold for 1 second to turn
the water flosser on
1.1]. Let water flow into the
sink.
5. Slide the water stream
along the outside of your
gums. Pause between the
teeth to remove any plaque
or food particles
[Figure 1.2].
EN
[Figure
9