Removing A Burner Base - Whirlpool GLS3064R S Manual

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug cooktop or disconnect power.
2. Turn off gas supply to cooktop.
3. Remove the cooktop from the unit (see page
3-2 for the procedure).
(30˝ Model Cooktop)
(36˝ Model Cooktop)

REMOVING A BURNER BASE

Burner Bases
4. Remove the 9/16˝ gas line nut from the
burner base.
5. Remove the two screws from the burn-
er base and remove the base from the
cooktop chassis.
Burner
Base
Screws
9/16˝ Gas
Line Nut
6. Remove the orifice from the burner base
using a 7 mm socket, and install the ori-
fice in the new burner base. Do not over-
tighten the orifice when you install it.
Burner
Orifi ce
IMPORTANT: Refer to the "Reassembly Note"
on page 3-3.
3-4