Removing The Rear Axle Drive Shafts - Mercedes-Benz Atego Manual

Removing the rear axle drive shafts

Engaging differential lock with bolt (HL4):
Remove cable connector 1 from shift cylinder
housing 2.
Unscrew switch using socket wrench (size
24 mm).
Carefully screw bolt 3 all the way into shift cyl-
inder housing 2.
Bolt M 18 x 1.5 x 60 mm
Special tools, see page 121.
If it is not possible to screw the bolt 3 all the
way in: Pull out drive shaft about 150 mm and
twist until the bolt 3 can be screwed fully home.
Guidelines for Breakdown Services (Subject to technical modifications)
(example)
(example)
Towing
109
i