Tv Setup; Speakers - Philips 36PW9618/05 User Manual

TV Setup

Speakers General Source Decoder
Setup
Test tone
Balance
Centre volume
Surround L volume
Surround R volume
Wireless surround
To front
To surround
Subwoofer
Auto surround

Speakers

Your TV is equipped with integrated front left, right
and centre loudspeakers, capable of reproducing
Stereo and Dolby 3 stereo modes.
For full Dolby Pro Logic II and Dolby Digital
surround sound use the two amplified rear
surround speakers.
Depending on the output and Surround mode (see
Main menu,TV, Surround, Sound mode, p. 14)
selected, some menu items may be greyed out and
are not selectable.
Test tone controls
The menu item
Test tone
balance the volume levels of the speakers.
& Select
Test tone
é
Once turned on, the Test Tone will circulate
through the left, centre, right speakers and both
rear surround speakers (if present).
" Press the cursor up/down to select the desired
speaker for individual volume level adjustment.
'
Press the cursor left/right to adjust the volume
level.
Wireless Surround
The system has already been configured in the
factory to work properly.
In rare circumstances, interference from
external RF (wireless) equipment such as RF
headphones, mobile phones or remote controls
for lights, may occur.
Then it may be necessary to shift to another
wireless channel.
Use the cursor left/right, up/down to select
another channel.
enables you to
and press the cursor right.
The Setup menu contains items that control the
settings of the TV's functions, features, services and
peripherals you may have connected.
The menu reflects the speaker-related
Speakers
controls.
The menu allows you to change settings
General
that will typically be accessed only occasionally.
The menu allows you to select a source.
Source
The menu allows you to define one or
Decoder
more programme numbers as decoder programme
numbers.
Important : Always be sure that the wireless
receiver box and the Wireless Surround setting
are switched to the same transmitting channel.
Otherwise no sound or only a distorted sound
will be heard on the surround speakers.
To avoid interference in picture the wireless
transmitter might be automatically switched off.
In rare cases, when no RF surround sound is
possible or when there is too much
interference, use the wired back up solution
with a 3.5 mm stereo jack. In this case select
Off in the Wireless surround menu item. See
Connect Peripheral equipment,Wired rear
loudspeakers, p. 22.
To front / To surround
Select or
To front
select the distance between the TV or the rear
surround speakers and the place you sit to
watch TV.
Subwoofer
Select if you want to use the internal
subwoofer or if you installed an external one.
See Connect Peripheral Equipment, Connect
extra subwoofer, p. 22.
Auto Surround
Sometimes the broadcaster transmits special
signals for Surround Sound encoded
programmes.
The TV automatically switches to the best
surround sound mode when
switched . However it is possible to
On
overwrite this setting.
and then
To surround
Auto Surround is
9