Wireless Surround Speaker System - Philips 36PW9618/05 User Manual

Philips matchline widescreen tv 36pw9618 91 cm (36") 100hz digital scan with pixel plus
Hide thumbs Also See for 36PW9618/05:
Table of Contents

Advertisement

Wireless Surround speaker system

WIRELESS MODULE
®
4
1
3
2
3
3
NXT ® is a trademark of New Transducers Limited
*
13V DC in
13V DC in
V DC in
AUDIO in
AUDIO in
AUDIO in
4 /15W
4 /15W
4 /15W
(TV)
(TV)
(TV)
2. 2.8V RMS
2.8V RMS
8V RMS
R
R
L
L
4
1
2
3
4
4
1
2
2
2
Wireless transmitter module
• Switch the TV off with the power switch.
• Attach the wireless module to the back of the TV as
shown.
• Connect the attached cable to the wireless module
connector.
• Switch the TV on.
Surround loudspeakers
• There are two NXT SurfaceSound
loudspeakers which have to be connected to the
wireless receiver box 2
connection cables is too short the
4 m extension cable supplied can be used. As well
table stands and wall supports are supplied.
• The Surround sound loudspeakers can be located
behind or to either side of the listener.The front of
the loudspeakers do not have to face the listener.The
distance between the TV and the surround speakers
should not exceed 15 m.
Wireless receiver box
Connect the
13V DC
1 input at the bottom of the receiver box.
IN
Connect the adaptor to the mains.
The slide channel switch 3 has been set default to
channel 1 in the factory.
The indicator on the receiver box shows that the
speakers are in standby. During sound transmission the
indicator turns to green. 10-15 min. after the sound
transmission of the TV has stopped, the indicator turns
back to red to indicate the low power standby.
The system has already been configured in the factory
to work properly. In rare circumstances, interference
from external RF (wireless) equipments such as RF
headphones, mobile phones or remote controls for
lights, may occur.Then it may be necessary to shift to
another wireless channel.
Important: Always be sure that the Wireless receiver
box and the Wireless Surround settings (see p. 9) are
switched to the same transmitting channel.
In rare cases, when no RF surround sound is possible,
or when there is too much interference, use the wired
back up solution. See Wired rear loudspeakers, p. 22.
®
* surround
and
. If one of the
R
L
adaptor supplied to the
13V DC
3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

36pw9618/5828pw961832pw961836pw961836pw9618/12Tv

Table of Contents