Troubleshooting; Additional Information; Warranty Information; Led Indicators - D-Link DGS-1008MP Quick Installation Manual

Setting up the DGS-1008MP
PoE Switch
This switch is a plug-and-play device.
1. Plug the AC power cord into a free wall socket,
then plug the other end of the power connector
into the DGS-1008MP. The Power LED will
illuminate confirming that the device has powered
up successfully.
2. Insert Ethernet cables with an RJ45 connector to
the 10/100/1000 Base-T PoE Ethernet port.
3. These ports also support automatic MDI/MDIX
crossover, eliminating the need for crossover
cables or uplink ports. Each port can be
connected directly to a server, hub, router, or
switch using regular straight-through twisted-pair
Ethernet cables.
Figure 4 - LED indicators

LED Indicators

The LED indicators allow you to monitor, diagnose,
and troubleshoot any potential problem within the
switch, connection, or attached devices.
LED Color
Green
Power
Green
Link
(Port 1-8)
Amber
2 2
State Indication
On Power on
Off Power off
Connection at
On
1000 Mbps
Reception or
Blinking Transmission at
1000 Mbps
Connection at
On
10/100 Mbps
Reception or
Blinking Transmission at
10/100 Mbps
Off No Link
Amber
PoE
(Port 1-8)
Off
PoE Max 1
Amber
(Port 1-4)
PoE Max 2
Off
(Port 5-8)

Troubleshooting

1. What should I do if a connected device is not
detected?
• Ensure the port LED is illuminated or
flashing. If not, try using a new LAN cable or
power cycling the switch.
2. What should I do if a PoE device is not powered
by the DGS-1008MP?
• Ensure that the total device load does not
exceed the maximum power budget of
140 watts.

Additional Information

Additional help and product information is available
online at http://www.dlink.com

Warranty Information

Please visit http://warranty.dlink.com/ for warranty
information for your region.
© 2015 D-Link Corporation. All rights reserved.
Trademarks or registered trademarks are the property
of their respective holders. Software and specifications
subject to change without notice.
PoE device
On connected and
receiving power
No PoE device
PoE device load over
On
budget
PoE device load
within limit