Table of Contents
Advertisement
7. Programming a recording (TIMER)
General information
Use a TIMER programming to automatically start
and stop a recording at a later time or date. The
TV-Video Combi will switch to the right pro-
gramme number and begin recording at the cor-
rect time. With this TV-Video Combi, you can
pre-programme up to eight recordings within a
period of one year. To make a programmed
recording, your TV-Video Combi needs to know:
* the date you want to make the recording
* the programme number of the TV channel
* the start and stop time of the recording
* PDC on or off
This information is saved in a 'TIMER' block.
What is 'PDC'?
'PDC' (Programme Delivery Control) is used to
control the start and duration of TV channel
recordings. If a TV programme starts earlier or
ends later than scheduled, the TV-Video Combi
will turn on and off at the correct time.
What do I need to know about 'PDC'?
Usually the PDC time is the same as the start
time. But if your TV guide shows a PDC time
which is different from the programme's sched-
uled start time, e.g. 20.10 (PDC 20.14), you
must enter the PDC time exactly to the minute.
If you want a start time different from the PDC
time, you must switch PDC off.
Programming a recording
(with the VIDEO Plus +
Thanks to this programming system, you no
longer need to tediously enter the date, pro-
gramme number, start and end time. All the
information needed for programming is con-
tained in the PlusCode number.
You can find this PlusCode number in most TV
listing magazines written next to the concerned
programme.
1.
1.
Press
on the remote control.
SV/V +
Error message: 'FULL'
• If this error message appears after pressing
then all TIMER blocks are already programmed. No
more recordings can be programmed. If you want to
clear a programmed recording (TIMER block), select
the programme number on TIMER LIST menu and
press
.
CLEAR
®
system)
SV/V +
,
13
2.
2.
Enter the entire PusCode number. This num-
ber is up to 9 digits long and can be found
next to the start time of the TV programme in
your TV listing magazine. [e.g: 1-234-5 or 1
234 5]
If you make a mistake, you can clear your input
with
.
CLEAR
VIDEO Plus + system
PlusCode No.
12345
SET=SV/V+
CORRECT=CLEAR
END=EXIT
SV/V +
3.
3.
Press
.
4.
4.
Select 'ONCE', 'DAILY' or 'WEEKLY' recording
with
or
PLAY B-K
.
FWD 1- B
VIDEO Plus + system
ONCE
DAILY
WEEKLY
SELECT K L CHOOSE B
END=EXIT
Selecting ONCE/DAILY/WEEKLY recordings
'ONCE':
Recording once
'DAILY':
Repeated daily recordings
(Monday to Friday)
'WEEKLY': Repeated weekly recordings
(every week on the same day)
5.
5.
The decoded data appears after confirmation.
You can go back to change the data. Select
the corresponding input field using
or
CLEAR
. Change the data with
. Then press
STOP C-L
FWD
1- B
0..9
.
EN
Advertisement
Table of Contents
