Timer Recording With The Vcr Plus+ Programming System - Philips Magnavox CCZ256AT Owner's Manual

CCZ256comb.QX33 4/6/99 9:14 PM

Timer Recording With the VCR Plus+ Programming System 41

Follow the steps below to program a timer recording using the
PlusCode programming numbers in your TV guide. Before you
begin, make sure:
The clock has been set. If not, CLOCK MUST BE SET appears.
Channels are programmed.
There is a tape in the TV/VCR (make sure the tape's record tab
is intact and the tape is long enough to record the program).
You have completed the steps on pages 39 - 40.
Complete each step within 60 seconds of completing the
previous step. If you don't, you may return to step 1.
1
Press the COMBI button, then press the VCR
PLUS+/ENTER button.
VCR PLUS+ PROGRAM
PLUS CODE : – – – – – – – –
TO END PRESS EXIT
2
Press the Number buttons to enter the PlusCode pro-
gramming number of the program you wish to record (this
number is different for every program, and it can be three to eight
digits long). Finally, press the VCR PLUS+/ENTER button.
VCR PLUS+ PROGRAM
PLUS CODE : 95557 – – –
TO SET PRESS VCR +
TO CORRECT PRESS CLEAR
TO END PRESS EXIT
3
To record the program once, press the Number 1 button
to select ONCE. To record the same program every day
from Monday through Friday, press the Number 2 button
to select DAILY. To record the same program every week
on the same say (such as every Saturday), press the
Number 3 button to select WEEKLY.
VCR PLUS+ PROGRAM
1 ONCE
2 DAILY (MON - FRI)
3 WEEKLY
TO SELECT PRESS NUMBER
TO END PRESS EXIT
Page 41
POWER EJECT
SLEEP SPEED MEMORY
REC/OTR PAUSE/STILL
PLAY
REW F.FWD
STOP
STATUS/EXIT
1 2 3
CH.
4 5 6
7 8 9
0
A.CH +100
VOL.
CABLE/DBS COMBI
1
VCR PLUS+
VAR.SLOW /ENTER MUTE
TRACKING F.ADV SLOW
SMART SMART SKIP INDEX
PICTURE SOUND SEARCH SEARCH
Helpful Hints
• If the timer recording will occur on a
Saturday or Sunday, you cannot
select DAILY at step 3. ERROR may
flash on the screen after you com-
plete step 3. Select ONCE or WEEK-
LY instead.
• You cannot set a timer recording if
RECORD DEFEAT is set to ON.
Details are on page 43.
• If CODE ERROR flashes after you
enter the PlusCode programming
number and press the VCR
PLUS+/ENTER button, the number
you entered was incorrect (for exam-
ple, too short). If this happens, enter
the correct number.
• CLASH may flash on the screen after
you complete step 2. This means
that the timer recording you just pro-
grammed and another timer record-
ing overlap, and thus the current
timer recording will not be carried
out.
3
2