Philips 55PP9501/79 User Manual page 42

Connect Peripheral Equipment
40
Connect External Speakers / Amplifier
&
AUDIO OUT
é
"
&
AUDIO OUT
S
é
&
é
"
Stereo amplifier and two extra FRONT speakers
To enhance the sound reproduction of your TV you can connect two extra
speakers via an external amplifier.
Connect the audio cables to the audio input of your amplifier and to the
VARIABLE LINE AUDIO OUT L
The output level is controlled by the volume control of your TV.
Note: Turn off the TV and your audio amplifier before connecting them.
Set the audio amplifier's volume to minimum.
Select in the Settings menu, Speakers, see p. 21.
Center Mode Yes
See Sound menu, Sound Mode, p. 15 for the available Sound modes.
Adjust the volume of the audio amplifier.
You may make use of the Test Tone function in the Settings menu, see p. 22, to
have a reference of the loudness of the separate speakers.
Note: Once you have adjusted the volume of the amplifier, do not change it while
watching TV as the whole configuration operates with the volume
adjustment of your TV.
Surround speakers
To enjoy Dolby Pro Logic Surround sound, you can connect two rear
speakers (16 Ohm only!) with built in amplifiers (or an audio amplifier with
rear speakers).
Connect the audio cables to the rear speakers and to the Dolby surround
output S in the
VARIABLE LINE OUT
shown opposite.
There is only one cinch output for both speakers. Use a mono to stereo
adaptor to connect two surround speakers.
Note: Turn off the TV and the rear speakers before connecting them.
Rear Surround speakers should always be located behind or to either side of
the listener at about 1 m above the seated listener's head.
Adjust the volume of the rear speakers.
You can use the Test Tone function in the Settings menu, Speakers, see p. 22,
to have a reference of the loudness of the surround speakers in relation to
the other speakers.
Note: Once you have adjusted the volume of the rear speakers, do not change it
while watching TV, as the whole configuration operates with the volume
adjustment of your TV.
Dolby Pro Logic Surround amplifier
Connect the Dolby Pro Logic Surround amplifier to the
and at the back of your TV.
R
Select in the Settings menu, Speakers, see p. 21.
Center Mode No
The audio output is now independent of volume, bass, treble and Sound
Mode settings.
Turn off the volume of the TV with the mute button ¬.
All volume settings, tone control and speaker connections have to be done
via the external Dolby Pro Logic amplifier.
If you want to connect more equipment to your TV, consult your retailer.
and jacks at the back of your TV.
R
grouping at the rear of your TV as
MONITOR OUT L