Control Panel - Silhouette Renoir SR001 Owner's Manual

OPERATING INSTRUCTIONS

CONTROL PANEL

Power Button: Press once to start the cooling function. Cooling temperature will default to
12°C (54°F). While the unit is cooling, press this button to stop the cooling function.
Note: In order for the power button to function properly the unit must be plugged into a
grounded outlet and the power switch must be turned on.
Up and Down Arrows: The temperature range of the unit is 12°C (54°F) to 17°C (63°F).
Use the up and down arrows to increase or decrease the set temperature in 1° increments.
°C/°F Button: The default setting is °C. Press this button to switch between °C and °F.
LED Interior Light: The interior light can be set to 'on', 'off' or 'motion activated'. The default
setting is 'motion activated'. The light will illuminate if there is motion within 1.5 m (5 feet) of
the appliance and will remain on for 3 minutes.
• Press the LED button once for continuous illumination. Continuous illumination mode will
display a lightbulb on the display panel. The light will be on continuously at 50% power
and 100% power when there is motion detected.
• Press the LED button a second time to turn the light off. Light off mode will display a
lightbulb with an X on the display panel.
• Press the LED button a third time to return to motion activated illumination. Motion activated
mode will display a lightbulb with lines around it on the display panel.
12°C
6