Filter Replacement; Troubleshooting; Assistance Or Service; In The U.s.a. And Canada - Whirlpool WHISPURE Use & Care Manual

4. Remove both filters and set aside. Do not try to wash and
reuse either the HEPA filter or the pre-filter.
5. Clean the air purifier with a soft, damp cloth.
6. Gently wash the front grille in soapy water.
NOTE: The grille is not dishwasher safe.
7. Reassemble the filters as shown in previous illustration.
8. Place the bottom tabs on the front grille into the bottom slots
in base of the air purifier. Push the top of the grille forward
until the grille locks into place.
9. Plug in air purifier or reconnect power.
10. Press POWER to start the air purifier.

Filter Replacement

NOTE: The filter indicator lights on top of the air purifier will glow
when it is time to replace either the pre-filter or the HEPA filter.
For the most efficient operation of the air purifier, under normal
conditions it is recommended that you replace the pre-filter every
3 months and the HEPA filter every year.
See "Replacement Filters" in the "Assistance or Service" section.
First try the solutions suggested here and possibly avoid the cost of a service call...
Air purifier will not run
Check the following:
Is the air purifier turned on?
Is the power cord plugged into a grounded 3 prong outlet?
Before calling for assistance or service, please check
"Troubleshooting." It may save you the cost of a service call. If
you still need help, follow the instructions below.
Call the Customer Service Center toll free: 1-866-666-1168.
Our consultants provide assistance with:
Features and specifications on our full line of appliances.
Installation information.
Use and maintenance procedures.
Accessory and repair parts sales.
Specialized customer assistance (Spanish speaking, hearing
impaired, limited vision, etc.).
Referrals to local dealers, repair parts distributors and service
companies. Designated service technicians are trained to
fulfill the product warranty and provide after-warranty service,
anywhere in the United States and Canada.
6

TROUBLESHOOTING

ASSISTANCE OR SERVICE

In the U.S.A. and Canada

Replace the filter regularly. The use of a non Whirlpool filter may
invalidate the warranty.
1. Press POWER to turn off the air purifier.
2. Unplug air purifier or disconnect power.
3. Place fingers on the front release tabs. Gently push the tabs
in and pull the front grille forward to remove it.
4. Remove and replace the indicated filter. Install the new HEPA
filter in the same direction shown by the arrow located on the
filter frame. Install the new pre-filter by placing it on the tabs.
NOTE: Do not try to wash and reuse either the HEPA filter or
the pre-filter.
5. Place the bottom tabs on the front grille into slots in the base
of the air purifier. Push the top of the grille forward until the
grille locks into place.
6. Plug in air purifier or reconnect power.
7. Press POWER to start the air purifier.
8. Press either the PRE-FILTER RESET or the HEPA RESET
button for 5 seconds to turn off the filter indicator light(s) and
reset timer.
Has a household fuse blown, or has a circuit breaker tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
Was a regular fuse used? Use a time-delay fuse or time-delay
circuit breaker.
When calling, please know the purchase date and the complete
model and serial number of your appliance. This information will
help us to better respond to your request.
To locate the designated service company in your area, you
can also look in your telephone directory Yellow Pages.