Thermador Masterpiece Series Installation Manual page 7

Remove the orifices.
4.
Notes
The orifices require a 7 mm socket driver for
▯
removal/replacement. The driver will need to be
inserted approximately 2
cavity to reach the orifice.
To reduce the chance of the orifice being dropped
▯
from the socket driver, add a piece of foam tape or
adhesive tape inside the socket.
Trim a small piece of the foam tape provided
A
with this kit (about
Fit this so the tape wraps against one side of
B
the socket so it stays in place.
The tape will fit to the orifice and help prevent
C
the orifice from falling out of the socket during
extraction.
Note: Save the NG orifices in case there is need later
to restore the appliance to use natural gas again.
Identify the correct placement of the LP gas orifices as
5.
layed out on the orifice package card (see image
below).
LP Orifices
The orifice sizes are shown in the white circles
corresponding to each burner as shown in the image
above. These numbers are engraved on the side of
each orifice. It is very important to install the correct
orifice size for each burner.
^ " (64 mm) into the burner
] " x ^ " / 6 mm x 12 mm)
Insert each of the LP gas orifices provided with this kit
6.
into the socket (using the small piece of foam tape to
ensure a tight fit).
Check to be sure the small piece of foam tape
A
used earlier is fitted to wrap against one side
of the socket.
When pressing the socket driver onto the ori-
B
fice, the tape will help the orifice fit more
snugly inside the socket. This will help prevent
the orifice from falling out of the socket during
insertion.
Notes
If converting one of the following units, proceed to
▯
steps 7 through 10: SGS305TS, SGSX305TS,
SGS365TS amd SGSX365TS.
If converting one of the following units, skip to
▯
step 11: SGSP305TS, SGSXP305TS, SGSP365TS,
SGSXP365TS.
Identify the correct placement of the LP gas venturis
7.
as layed out in the image below.
Note: The venturis are identified by grooves running
around the lower section. The below image shows the
correct venturi placement with their corresponding
burners. It is very important to install the correct venturi
size for each burner.
Model SGS and SGSX LP Venturis:
7