Table of Contents
Advertisement
1-6. Arranging Harness
When repairing the unit, arrange and clamp the harness as
described in the following steps.
Improper arrangement of the harness may result in a
disconnection or awkward turn of the VF tube assembly.
1. Arrange the 8-wire harness as shown in the figure and
clamp it at point A so that it is not in contact with the
inside of the VF tube assembly or the lower chassis.
VF tube
assembly
Lower chassis
1-4 (E)
8-wire harness
A
2. Clamp the high-voltage cable and the 8-wire harness at
point B.
3. Clamp the 8-wire harness at point C.
4. Arrange the high-voltage cable as shown in the figure,
and then clamp it with the VF cable at point D.
B
8-wire harness
C
VF cable
High-voltage cable
D
DXF-20W
Advertisement
Table of Contents
