3.4
Installing the additional module WTX 200 I/O board
Fig. 19: Additional module with jumpers
1.> For installation version 6, set jumpers to additional module as shown in Fig. Fehler! Verweisquelle
konnte nicht gefunden werden./1.
Other information/examples
"Set-up and pin assignments for WTX 200 I/O board
" on page 32
"Assignment options of the additional connecting facilities (pins 1-6)"
on page 33
Example "Use of additional module 4 for additional analogue/digital outputs"
on page 34
Example "Use of additional module 2 for additional relay outputs and 1 additional
analogue/digital input
" on page 35
Fig. 20: I/O board spacers
2.> Fit spacers to controller at additional module.
3.> Remove cover from controller.
Assembly and installation
29